The WeldTec Designs "No What-if's" program for vans

[Weldtec Designs]

In the past few months we have had numerous inquiries wanting to know If our 2 wheel drive suspension components can be used with 4x4 conversions. Of course there are so many variables in these questions for it to be a simple answer...... So we came up with this......

http://www.weldtec-designs.com/blog/

Thanks for looking.

 

[REDOVAL]

Awesome, especially for those who can't make up their mind. I'm glad I stuck with 2wd, but it's nice to know there is an "out" if I change my mind.

Scott

 

[philos]

Nice gesture


Sent via flux capacitor

 

[Haf-E]

How much work would it be to install the transfer case without the front axle in a conversion to allow for a low gear? That, together with a good rear axle locker, your lift and good tires would probably be enough for 90% of expo needs. Does the gas tank need to be modified? Thanks.

 

[Grngiant]

The tank must be modified. The front output of the transfer case and the front of the fuel tank share the same space. Tank needs to be shortened.

 

[ert01]

That is an awesome offer Weldtec! I have a feeling your components will be popping up on more and more vans here if you guys keep this up!

 

[Grngiant]

All you have to do is drive one and you will be sold on its value and performance.
I would be happy to take someone for a ride in my van if they are in the central Vt area and wants to check it out.

 

[Weldtec Designs]

All you have to do is drive one and you will be sold on its value and performance.
I would be happy to take someone for a ride in my van if they are in the central Vt area and wants to check it out.

Thanks Kevin, I hope some of the folks out east take you up on that.