torsion crank question. but not a how to.

[twistedsmily]

I was wondering. How much is everyone cranking their bars.
I just did 5 turns on mine (2wd) and its just almost level with the back. Was thinking about 2 or 3 more but not sure.

 

[xkid]

Don't you want a rake?

 

[twistedsmily]

Id like a more level ride. But not sure how much lift per turn is achieved.

 

[SoCalMonty]

A: However many turns it takes. As the bars wear, 4 turns on mine might produce a different result than 4 turns on yours. Measure each side every few turns, and make sure you don't run out of threads on the adjusters (if you do, you'll have to re-index the bars. Takes about 15 mins).

 

[twistedsmily]

Oh ok. So more trial and error thing. Ok. Guess ill give it a few more turns and see what comes of it.

 

[SoCalMonty]

It probably is, but make sure the front tires are in the air (jacked up). And you might end up resting on the bump stops; check for that once you lower the truck again.

 

[twistedsmily]

round up going with 8 turns ,

You talkin about the droop stops. On the upper controll arms. Still have little less then an inch from them might trim them down a bit.