Hello, I am planning on building a cab over camper for my 2010 Silverado 2500 Extended cab. I have decided on a 2x2 frame. Glued and screwed. Most likely 2x4s ripped down. Xps foam insulation. I was planning on doing poor man's fiberglass as the skin but found a supplier near me that has aluminum sheets.
My new plan was to do 1/4in ply, varnished for waterproofing. Then aluminum sheets over that, screwed around the edges to allow for airflow, with butyl tape under the seams and edges. Finally aluminum trim over the seams and edges with some screws and adhesive.
This is my first time doing something like this and it's pretty cold near me right now so I was worried about PMF curing properly. If anybody has any suggestions they'd be greatly appreciated
My new plan was to do 1/4in ply, varnished for waterproofing. Then aluminum sheets over that, screwed around the edges to allow for airflow, with butyl tape under the seams and edges. Finally aluminum trim over the seams and edges with some screws and adhesive.
This is my first time doing something like this and it's pretty cold near me right now so I was worried about PMF curing properly. If anybody has any suggestions they'd be greatly appreciated