Recent content by monkeyodeath

I've decided that my next camping project is to bring a little water pressure into my life. My initial thought is to use one of the many available 12v diaphragm pumps to pull water from a Scepter can into a sprayer head. Main use would be washing dishes and gear, but it would also be nice to...

Oh, price I was quoting was for a bank of 4 of those batteries to get to 12v.

Appreciate all the advice. Thanks to jonyjoe101 for the tip about checking the charge voltages. I myself was surprised that the group 34 battery wasn't cutting it -- figured it would be enough. I'm also seeing the wisdom of going for the higher AH rating despite the cost. That much overkill...

I've decided to take a crack at building a DIY LiFePo4 battery setup for my rig. My current setup is a 300W solar panel and a Group 34 lead acid battery. I'm running an ARB fridge and occasionally a diesel heater. No real plans to add anything else aside from maybe a 12v oven for giggles at...

Thanks for all the advice and suggestions. Spent some time watching my solar setup and measuring things with a multimeter and I'm pretty convinced that I've got plenty enough solar power. Even on a cloudy day, my panel is able to come up with enough amperage to both charge the battery and run...

I looked and there isn't one. People seem to use the AGM preset or input their own parameters (which are really close to the stock AGM ones).

Re-measured the panel and it's about 5' x 3'. It's a Sunpower residential panel rated at 305W. I really don't think solar is my bottleneck here. I've monitored the MPPT and the historical logs and there has never been a day when the battery did not get fully charged from the solar panel...

Panel is 300W residential solar panel about 3.5ft x 2ft in size. Looking back at the MPPT logs, the battery is getting fully charged every day, and usually pretty quickly.

Spent some time looking through the MPPT logs... I had inadvertently set the fridge to a "medium" battery voltage cutoff, 11.4V. I'm guessing that this is too low, so I set it to the "high" setting of 11.8V. Is this still too low of a cutoff voltage for a lead-acid starter battery? Looking back...

Looking back through the MPPT logs, the fridge pulls a little more than 5A when the compressor switches on.

It's set to a bit above freezing. When I'm using it, it sits in a truck bed with pretty decent ventilation.

I think I'm at a decision point for my fridge power setup. I've got a 300w solar panel on my RTT attached to a Victron MPPT. Only thing I use it for is an ARB Elements fridge ( the bigger one ). I'm having issues with the fridge shutting off and the problem (I think) is the battery. My first...

I have considered CO2 before (mainly cause I have a tank from a homebrew phase from a while back), but not really excited to have yet another consumable that I've got to keep track of on the truck. Honestly I'm not too particularly bothered by the slow fill times of the Viair, at least for the...

Awesome advice, thanks everyone. I do like the idea of being able to get a little air spray action to clean stuff out, and I've been pondering building a low-pressure circuit to drive an outdoor shower/faucet from a Scepter can -- tank would be helpful with that. But good to know it's not...

Sorry if this is a basic question, but after a bunch of searching I'm having a hard time getting a straightforward answer: I've got a first-gen Tacoma on 33"s. Right now I use a Viair 300P to re-inflate my tires. I do not use air tools. I notice that a lot of folks add a 10 or 20 gallon air...