Search results

  1. E

    FS ARB Simpson III RTT w/Annex

    I'm putting my ARB RRT up for sale. It merely an age thing for the wife and I that consider selling it. The tent is in excellent condition. No tears, holes, damaged zippers, broken pieces or excessive wear. The annex shows some modest staining on the PVC skirt from ground contact. Also includes...
  2. E

    Pair of 5 on 5.5 to 5 on 6.5 adapters

    I used these on my M416 trailer to fit Land Rover wheels. Since building my M101cdn using LR spindles I no longer have use for them. I'd have to measure again but I think these are 30mm thick (enough to clear the M416 wheel studs). Excellent condition. $100 plus the ride.
  3. E

    Camping Lab RTT and annex for sale

    I'm selling my RTT I've owned for a few years. It's seen a dozen or so uses. The tent and annex (Mosaba brand) are in excellent condition. The vinyl cover doesn't leak and the zipper is good The cover does have the typical wear from exposure. The attached photo shows it in use including a/c...
  4. E

    M101CDN nearing completion

    The original build is here, http://www.expeditionportal.com/forum/threads/125719-M101CDN-build , I've completed the main topper and will fabricate the lift gate this weekend. Both sides open fully for easy access. While it appears top heavy the topper only weighs about 75 lbs at most. the RTT...
  5. E

    M101CDN build

    I picked up this trailer to build my camping rig. It was disassembled, chopped up for the tail gate, longer A frame arms fabricated and extended tube out the back for a rack. The bed was reinforced with two extra cross members. All those parts were galvanized before etching primer, seam sealer...
  6. E

    Alternate to M998 LED tail light

    I've been trying to figure out an alternative to the Trucklite or Grote HMMWV LED tail lights at $+$120 each. The original ideas were to replace the bulbs with expensive LED bulbs or build my own circuit boards. On a fluke, I picked up a Blazer C542RTM for $18 at Walmart. The red lens was busted...
  7. E

    CDN M101 axle build

    I've had this M101 for a while with plans to fix up as a replacement for my M416 one day. Anyhow, I'd pulled the axle and springs a while back. The springs were disassembled, sandblasted, primed/painted and reassembled using poly sliders and new bushings. The old axle with that 112mm bolt...
Top