2005 F-450 4x4 Utility Body w/ Starcraft Pine Mountain Lonestar Pop-top Camper

[Bubblegoose1]

Today, before the sun attacked me, I installed the center supporting PVC feet, and connected and secured the wiring. I made the PVC feet 1/4" taller than the frame height; giving a slight upward bow, rain run-off, and hold-down pressure on the feet. Now I have just the two leads ready for controller and battery connection.

 

[Bubblegoose1]

Solar completed this morning. HAPPY

 

[Bubblegoose1]

On an overdue, welcomed, beautiful PNW cool and overcast day, solar is still putting out a fluctuating 68+ to touching 70 volts. Impressed

 

[Bubblegoose1]

Yeah, this is happening. Spring here yet?

 

[Bubblegoose1]

Had some ceiling water damage from a poorly installed massive satellite receiver that the previous owner installed. Satellite ditched, leak repaired and all dry now for a couple seasons. Did a nice world map install today. Satisfied

 

[kerry]

Like that solution. I have similar damage. What did you use to hold the map up? Is it a fabric map. Where did you get it ?

Had some ceiling water damage from a poorly installed massive satellite receiver that the previous owner installed. Satellite ditched, leak repaired and all dry now for a couple seasons. Did a nice world map install today. Satisfied

 

[Bubblegoose1]

Like that solution. I have similar damage. What did you use to hold the map up? Is it a fabric map. Where did you get it ?

Hi Kerry,

Thank you for the compliment.

I used a very lightweight fabric tapestry map, and push tacks to hold it in place. The ceiling material proved to be a really good hold with the tacks, plus stretching the material some creates side torque (holds in place as well). If any tacks fall out, I will graduate to screws, industrial velcro, etc.
Link:
HMWR Ancient World Map Tapestry Wall Hanging Art Decor Light-weight Polyester Fabric Wall Throw Artwork Home Decoration for Living Room Bedroom Dorm 80x60 Inch https://www.amazon.com/dp/B06Y61Y1K2/ref=cm_sw_r_cp_apa_i_fQ-PCb4TAE0CW

 

[kerry]

Thanks

 

[Pacific Northwest yetti]

Have you been able to get out yet this year?

 

[Bubblegoose1]

Have you been able to get out yet this year?

I have not. Had a couple vehicle projects to get in order, a job change, then some out of town (flying) trips to do. In Vegas right now for work. Whew. Been busy.

Soon, very soon, getting out there somewhere. I need a break.

 

[Pacific Northwest yetti]

I hear you, just wanted to check in on one of my favorite builds! I hope things slow down for you, my life is about to change as well w/ a job change.

Congrats on that!

 

[Bubblegoose1]

Thanks for checking in. Yeah, plate has been full for a bit but slowing down soon.

Congrats on your change as well.

 

[Bubblegoose1]

Haven't been able to experience any adventures lately; 3 job changes since last August and some family responsibilities. But, things are beginning to settle down.

Took a few hours this morning to wash the PNW Winter off of her. She cleans-up pretty nicely, I think . Getting ready for my first NW Overland Rally attendance.

But first, going to be swapping out those fake ARBs for Baja Designs LP9 Pro Spot LEDs that I've had sitting in a closet for way too many months.

 

[Bubblegoose1]

Started the change-over of lighting today. Baja Designs LP9s mounted. Wiring harness install this week. Ran short on time today.

 

[Bubblegoose1]

Enjoying the sights and activities at the NW Overland Rally.