s.e.charles
Well-known member
next step before the weather gets much cooler is to apply some 1/16" aluminum flat strips to the roof of my contractor cap. (yes; the one i could not even give away!)
i've had good luck with adhesion results using 3M VHB tape, just not sure of its waterproofing ability. i have found value in using the 3M adhesion promoter, too.
Q: can i use this instead of butyl rubber tape between the aluminum & cap sheathing (also aluminum)?
i will be replacing the self tapping factory screws with nutserts & truss head machine screws. these will go into the cross ribs of 1" x 1" aluminum tube that ARB used.
thanks
i've had good luck with adhesion results using 3M VHB tape, just not sure of its waterproofing ability. i have found value in using the 3M adhesion promoter, too.
Q: can i use this instead of butyl rubber tape between the aluminum & cap sheathing (also aluminum)?
i will be replacing the self tapping factory screws with nutserts & truss head machine screws. these will go into the cross ribs of 1" x 1" aluminum tube that ARB used.
thanks