FS- 99-04 Tacoma bed rack V1.0 for RTT

[Desertdude]

Used needs a bit of re-welding at the elbows. But works fine as it is with cable ties and tightening couplers. Bolts down through rails to mount. Black powder coated.

75.00 local pick up in Sedona AZ (I can get this to Central CA)

Paypal accepted

 

[Desertdude]

Operators are standing by call now...

 

[Desertdude]

you know you want this :jumping:

 

[slosurfer]

Will that fit on a m416 trailer (or canadian m101)?

 

[Desertdude]

Hey Chris, The rack measures at the angle iron which goes over the rails

Length of L angle = 56"

Inside width of L angle =57'

 

[slosurfer]

Thanks Pasquale!

I just measured and it's about 7" too wide and 18" too short. The length isn't a big deal, as it would actually allow you to move it forward or back depending on how you need to balance your load. The width would be a little harder to come up with a good solid mounting system. I'm sure it could be made to fit, if I was closer, I might give it a shot. Oh well......

Either way, here's a bump for ya.

 

[Desertdude]

Bump

 

[Desertdude]

Operators standing by...

Traveling to Central Coast CA Via Las Vegas and maybe Reno end of this month could deliver...

 

[Desertdude]

Up for more air :smiley_drive:

 

[Desertdude]

Ttt