Help my ARB is too big!

[SEETHEWORLD349]

I have a Arb twin compressor and I was planing on having it under the hood
Slee tells me is too big to go under the hood (dual batt )
And they tell me they dont recomend inside the car ( rear quarter panels) because of cost amount of work and posinle odors.

So all i can think of now is throwing it up on the rack ( bajarack long rack)
Bolted in a metal case , bolted to the rack
Permanent instalation bring the lines downunder the snorkle and into the engine bay

Also use the case to store the tire inflation and repair kits

What nice cases would get the job done?

Plastic or metal?

Anyone know the actual dimensions of a twin compressor??

Mine is in the box in my warehouse

Thank you all

 

[Ramjet]

I've seen quite a few mounted inside the vehicle on the driver side rear qtr panel. As long as you're not running it with the doors shut and windows up, you should be fine. Look at MPAC Racks and check them out for mounting options.

 

[92hdj81]

This is where I decided to mount mine.







The tank under the back:



Getting the lines from the tank to the compressor was easy because there are two holes there already.

I am going to extend the air intake from the compressor to the outside of the back panel so it has cool clean air.

 

[hoser]

Or sell it and get an engine driven compressor. Should fit, unless you have an SC.

 

[enzo]

Just sell it to me.