(Double post from my design thread in case there are some ideas of folks in this section of the forum not in the pop-up area).
This is for my camper build. Over lapping hardwall design, need to figure out how to open the outer door when the top is down and thus the inner door is blocking it.
I was thinking of using basic trimark RV handles like this:
My door thickness is 2", since the above handles are for 1.25-1.5" doors that helps me out so I can recess the inner handle mount .5-.75" into the door. I was thinking about putting cable controls into the door core and routing the actuation part near the top of the door (which would be above the inner/lower door). The lock latch is just back and forth which would be fairly easy, the latch release would likely need to have the cable control drilled into the housing to actually pull the latch release. Thoughts or better ideas?
This is for my camper build. Over lapping hardwall design, need to figure out how to open the outer door when the top is down and thus the inner door is blocking it.
I was thinking of using basic trimark RV handles like this:
My door thickness is 2", since the above handles are for 1.25-1.5" doors that helps me out so I can recess the inner handle mount .5-.75" into the door. I was thinking about putting cable controls into the door core and routing the actuation part near the top of the door (which would be above the inner/lower door). The lock latch is just back and forth which would be fairly easy, the latch release would likely need to have the cable control drilled into the housing to actually pull the latch release. Thoughts or better ideas?