New trailer

[R_Lefebvre]

It has torsion axle on it so I'm trying to figure out how to get some height out it.

Looking at pictures of torsion axles it looks like you could place a 2x2 on top to gain height or at the four mounting points there are 2x2 flat plate welded off the frame maybe a body lift at those spots?
It does need a little height gain, I dont plan to take it off road just through a forset service campground. I still have the M416 for off road trips.

If you use the 2x2 tube, I would suggest drilling oversize and installing sleeves in order to achieve a good clamp load. I've tried clamping across tube before, and find that it's excessively compressible, so it's difficult to achieve a good clamp load.

 

[indiedog]

Nice trailer! I like the slide out table/kitchen in the rear - gives a bit of versatility to the standard teardrop design. One thing though. I note there is no wall between the "kitchen" and bed area. I thought that this dividing wall usually found on teardrops was an integral part of the structure providing cross bracing. I would be a bit concerned about the RTT on top if there is minimal structure for racking internally. If it stays on the hardtop it wouldn't be so much of a problem.