Great find! I have been using the Iggycorp lid with two 5-gallon Scepter water cans and a Dometic faucet in my OVRLND for the last two years, works great!
One word of caution...at least on the first one I bought, I cracked the top of the cap from tightening it to the water can. I recently...
I have a 4" mattress from Roam Rest in my camper - I just stack the mattress halves on top of each other and then pull the bed platform back 6"-8" - top closes fine that way. It also leaves room up front where we store our down comforter and pillows.
I'm sure you can leave the bed slide all the...
@KellyM It looks like you have a Truma furnace mounted on the wall there... Any more pics of how you have that mounted? Did you install it yourself? Or was it done by an installer?
I had the same question - had planned to use flexible lines , but have seen most installs use copper hard lines. Are there specific reasons for the hard lines?
Very expensive, but this is the nicest diesel heater port I have seen anyone come up with so far:
https://www.etsy.com/listing/1821602333/heat-link-the-ultimate-diesel-heater
Yep, love my full barn doors! Highly recommend.
Install was easy, three holes to drill on each doors, add some bolts and they are installed.
Getting all the gaskets added and the doors sealed was a bit of work and trail and error, but it was easy enough.
I’m looking to add an external solar port and shore plug to my camper - when you added those plugs how are you attaching them?
Through bolts w/ nuts on the inside? Screws? Would rivets through the skin work?
I’m assuming some kind of sealant behind the plug as well?
Barn door extension install was super easy, drill a few holes throw in some bolts and they mount right up.
Took more time to add all the gaskets to seal them up than it did to install the lower barn door halves.
I drilled a hole beneath my 3rd brake light and installed the camera there.
I did end up making a harness to connect the aftermarket camera to the harness for my factory camera under the bed, but that was pretty easy.
Edit: This was the camera I used, have one in the front grill as well...
Thanks @dstefan - super helpful! Good to know AT was willing to install on a different brand of camper.
I had planned on buying a Truma from this place and installing myself: truma-varioheat-eco-campervan-gas-heater.
Was thinking of mounting it like AT's normal installs on a sheet of ABS or...
@dstefan Do you have any more pics of how you mounted this to the camper itself? Or of the exhaust fitting on the exterior?
I want to do this on my OVRLND, just trying to get a better idea of what it takes.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.