Recent content by emtmark

Yikes that may be the unobtainium category. A lot of folks put a plastic water cell of various sizes in the spare tire gap. Putting the spare on a swing out in the back helps to offset the ridiculous tongue weight. Sent from my iPhone using Tapatalk Pro

Bumping it up Sent from my iPhone using Tapatalk Pro

Just burning it up. Sell it all this week to expo member for 250$ less. Next seven days starting today :) Sent from my iPhone using Tapatalk Pro

Links below for the following steal of a deal!! Tepui Autuana 3 ruggedized pre Thule buyout, with annex, upgraded siesta mattress from Tepui themselves, spring poles and mounting hardware. Overland pros freestanding 270 drivers side awning with wall set and mounting hardware. Engel fridge...

Don’t know why all the filler crap I can’t seem to post without it Sent from my iPhone using Tapatalk Pro

I got an email Back from them about replacing the rails It was like...

I was at the SoCal overland expo and thought the boys would like to see the ol scout in action. They said they would love to see it. Then two days of zilch, I was a sad panda lol. I would have loved to have had them get me the right part numbers for the big slides in the back. Sigh I can tell...

You wore out the drums! What happened! Sent from my iPhone using Tapatalk Pro

Anybody upgraded the rear door hinge? What did you use how’s it working out? Sent from my iPhone using Tapatalk Pro

Yes and did you contact the mothership? Keep us updated please Sent from my iPhone using Tapatalk Pro

I am it’s slower but doable a full size truck would be better Or Hear me out A vk swap Sent from my iPhone using Tapatalk Pro

Tried out a new diesel heater for the tent installed a stove jack in the new awning and BAM 17 degrees of no problem later lol Sent from my iPhone using Tapatalk Pro

Hey man I’m so sorry. You did a lot of good sleuthing though and for that top marks! Sent from my iPhone using Tapatalk Pro

How is this not the drunk drivers problem? Sent from my iPhone using Tapatalk Pro

Retrofit update, getting better at not drawing blood handling cutting and installing the stainless mesh! The second mixer went onto the .50 can and I made a new burner out of 3/8” copper tube. BUT! The orifices I drilled for the copper burner may be to small as the gas backed up or something...