Search results

Interesting. I am reminded of when I wired in my canopy's brake light. Started with both ends of wiring harness where the run along the frame junctions towards the two tail lamp housings. Made a cable that passes-through and junctions off from the brakelight signal. Other signals are...

Had you taken any measurements pre- and post-springs? I measured at my wheel wells, in front I was at 33 7/8" at the top of the wheel well before, and 34 11/16" afterward, for a difference based on tires of 13/16". I fully expect that as I upfit this will increasingly negatively affect ride...

Pictures would be nice. Even if I don't go your route, seeing what others have done is helpful for figuring out what works.

I think that I had something in-mind simpler than what you've described. That said, I'm not an expert, hence registering for this forum. I was thinking something more along these lines: Now that said, I'm aware that I'm omitting things that would be required like battery cutoff for AUX...

Were those OE springs or aftermarket? I've found information on the aftermarket ACDelcos and it appears that Moog info is available too. Nissan only publishes p/n, not actual dimensions, wire size, or load rate. The 255/75/17 gave me somewhere between 3/4 and 7/8 lift over the 265/70/16 that...

Hey all, Have a '15 Nissan Frontier SV 4x4 Crew Cab with the 6' bed, looking to do some fairly simple upfit to make it more capable for backcountry and crosscountry use for a small family. So far I've put on Trail Ridge towing mirrors, installed an aluminum engine skid plate, and replaced the...