Search results

I'm just trying to get them to send be an equipment list of the components shipped to the retailer on my D15. The ICECOE VL90 fridge is shot; won't get below 45 degrees F on a cool night. ICECO won't cover compressor unless I have a Proof of Purchase; but my retailer's bill of sale doesn't have...

I have the same happening on the driver/rear roof latch.

I just got back from a 2K mile trip down south and I'm getting better at speed control in interstate traffic: I only had a few rocking situations that I had to tame. What really requires my attention now is going over rough patches when traveling at 60mph or higher. The bridge overpasses in...

After testing the amperage coming from the Dwellers Anderson connector, I rewired the Anderson connector on the fridge supply line: I got two new leads and did a proper flood solder instead of a crimp. I also noticed that the Anderson connectors weren't "clicking" together when plugged in. I...

Yes, 8 hours before loading it with refrigerated food, I got it down to mid thirties.

Just got back from a trip with the D15 down in the Southeast US and experienced cooling issues with my ICECO VL90Pro. The first day when the temps outside were about mid 50's F, the fridge didn't get past 42 F when set to 27 F. Then as we got further south and temps were closer to 65 F, the...

McHitch servicing. Kinda helpful.

I see a colon as if you were posting an associated link to the product you purchased, but it's not rendering. Can you try again? Tx.

Pipe Camlock female Camlock male 40mm adapter Elbow Site editor butchered the links on the first try; hope this works.

Anyone find a use for the awning rails on the camp side of the Dweller? A while back an Opus dealer told me that Opus was coming out with a rear awning to cover the bed fold out on the Opus that's very similar to the Dweller's config. I was hoping to be able to use these for something. Maybe I...

Anyone have problems with the little sliding plate on the fresh water cap's lock? One of mine won't budge unless I pry it with a blade: Tried a bit of lubricant, but it didn't do anything. The internal spring still seems to work, because it'll slide back. It's just that a key won't move it out...

So far, I've only used it to refill the toilet water reservoir and rinse off some beach sand.

Or which of the dozen keys opens which door.

Update on my skylight leak. It looks like they used regular caulk around the housing instead of self-leveling lap sealant; probably because they didn't want to interfere with the skylight lid closing. The caulk was definitely lifting up from the roof. The part attached to the plastic housing...

I have a 2018 Chevy Silverado (no lift) with a 2" receiver sitting at about 19" off the ground. The dealer installed the mchitch to a 2" Curt shank to get a 2" rise. At the time I was worried because when dry, the trailer was sitting a little high at the hitch. But with a full load it's almost...

Mine came with a lock set for the retaining pin to prevent unhitching.

Thanks for that info. I only pre-cooled for about 8 hours, so maybe I should experiment with a longer cool down. I plan on getting up on the roof this weekend and looking for dried out or loose caulk. What kind did you use to reseal? Yes, we've adopted a tilt forward setup (also helps to keep...

Nice! Here's my wife's solution: velcro attachment. Needs a rollup bar like yours.

Had a nice trip to the tidewater region of Maryland and Virginia. A couple of lessons learned: The refrigerator struggled in direct sunlight with temps above 80. On solar, I had it (the ICECO variant) set to eco mode with both sides targeted at 32 degrees F and it only got below 45 after...

Yes, I swapped it out for an Anderson plug. Can't post the Amazon link for some reason, but here's what you can search for: Anderson Power Products SB50 Connector Kit, 50 Amps, Gray Housing, w/ 10 12 AWG, 6319 (1 Pair)