Search results

marlin crawler has some nice ones out of 1.75" for under 200, they are weld on, but thats a pretty good deal, it will cost you close to that with buying parts and time

Sometimes when i upload the track onto my 60CS from mapsource it sometimes displays a messege that says "truncated" and the track is not fully uploaded to my gps. Why does that happen?

where exactly is this place?

So I am beginning my storage planning for the back of my tacoma. The design will be focused around the items i will be putting into it obviosly. I dont want to go into detail about what I am thinking just yet but i was hoping i can get some resources on storage bin suppliers that offer various...

most likely be going with the marlin crawler ones they seem to be the most price friendly

I have a tacoma

I will be getting some sliders here in the near future. My question is what is the correct way to mount them. Should they be even with the bottom of the frame rail? Or tuck up underneath the cab? I also see on pictures that most are slightly angled up, about 15 degrees or so. I guess that is...

yea i was actually thinking about that as i was going to sleep last night haha.. What did you do to fix that? If not, its not the end of the world i guess...

So i was faced with the dilemma that most of us have...how to mount my hi lift onto my tubular arb bumper. After searching around on the net the only thing i found that is somewhat suitable is this thing made by fourtrex, im sure most of you guys are familiar with. To me the thing looks pretty...

I see some are running either dual transfer cases or upgraded ones with even lower gears. I run a 4wd tacoma with stock components as far as drivetrain goes and when i go wheelin and encounter obstacles i cannot conquer(have not been many) its usually not because of drivetrain issues. I am...

What do you mean by not too unreasonable, like how much would 25 bolts run you

I just ordered these from McMaster: Four different sized bolts of a couple lengths with nuts, lock washers, and flat washers and a compartment case all for $150, pretty good id say. They are not all of the highest grade but I dont think they need to be 1 1 Pack 90854A167 Metric Znc Yellow Pltd...

Does anyone know off hand the specs(thread type, pitch, length) of the most common toyota bolts. I want to put a collection togther to bring with me on trips, you can only borrow bolts from other parts of the truck to an extent.

Its obvious a lot of you had done some serious expeditions and probably have broken down a long the way...from all your experience are there certain spare parts that are a must have on board. I want to avoid finding out what I should have brought along the hard way and was hoping to use all your...