Search results

You'll need to drill the lower perch for the Daystar Cradle. One bolt is all that is needed. Everything else is bolt on.

Got my hands on a RSI Smartcap EVO Added some HardKorr Lighting LEDs with a panel I made for the switch control

Here is a bit of an explanation for what's going on in my rear end. For all the inquiring minds.

Update time! Few small bits added... New Bulletpoint Mounting Solutions mic holder Added the Fox ATS Steering Damper Tight fit but it works well. Simple single bracket install and adjust to you liking. Jury is still out on if it's worth the price tag. (Sorry for the crappy photo) New...

I've still got this Bed Rack for sale if anyone is looking. Make an offer.

For Sale: Expedition One Bed Rack and MAP panels Fits several models, do your own research. It was on my 2019 Power Wagon 6'4" bed Pickup in NC only. (Too big to ship) Msrp $ 1200 plus shipping Selling price: $900 Bed rack and panel ONLY - No accessories shown. Ready for pickup immediately.

I just recently got back into cycling, more specifically gravel bikes. It's been a blast like you mentioned...just out riding and find a gravel road, go explore. Not to say you couldn't do that on a regular road bike; but it's way more comfortable and less likely of a puncture on a gravel...

Here's my 2019 Power Wagon and the Runaway Camper Venturist. Good combo.

With the rear coil spacers? No, nothing out of the ordinary. Now, with the rear trackbar and sway bar...that made a hell of a difference.

It's a simple flat bracket I made. Just get the NMO flat mount from Midland and figure out how far out you want to be on the A-pillar light mount. I'm using the BajaDesigns light mounts, just attached the bracket off of that.

Crap, yes. I'll fix it. Sorry about that. And thanks for catching it.

Articulation is not affected by the airbags. The lower portion of the bag is not attached to the axle, I'm using the Daystar Cradles to capture the lower and provide free movement for articulation.

The spacers I used are Traxda, part number 605041. They are metal and a simple install.

I do have the 360* system. It functions as factory intended with the exception of being off-centered and lower. A portion of the tire does show up in the backup camera but it's not enough for me to care. YRMV. *You'll also lose your parking sensors with the Rigd carrier.

And here is how it currently sits.

I did my own camera addition. You can see it off to the left above the license plate. Added a plate light as well. I left the factory camera in the factory location, just added another. One wire disconnect and the Rigd carrier can be taken off and all is back to stock.

Reworked the suspension with AirRide 5000 bags. I can now adjust the ride height, level the load and account for the camper or whatever else may be pulled. Plumbed the air lines to the rear bumper area and I just manually fill them as needed with my battery/12V Dewalt portable compressor. It...

Added the Rago/Rigd UltraPlate to the Ultraswing. Then the Frontrunner table with the all-weather cutting board. I like it, it gives another flat surface to work from and makes use of the space. Mounted my shovel with QuickFist under the table. Works out well.

A little update: Changed up the dash mount - Phone holder / GMRS radion mount. Bulletproof Mounting Solutions Ram Mount It is the simplest mount to install, two screws and some preinstalled 3m tape and you're done!

13.6 on this past weekends trip thru the mountains of western NC. I'll avg. 10-11 in stop and go traffic in town on short commutes. I've seen 16.5 pulling my camper in the mountains, but I think the wind was always at my back. (IE: Unexplainable)