Search results

Sure does (locker) I'm not much of a Sport fan, but this one looks pretty nice.

Nice POMs!

There is a thread on here about the $50 dollar solution

If the OP does not reply, I think I have at least 2 available.

Very early Gen 3 here in the states. MY '01 and part of MY '02 IIRC. The MY '03 and after have the redesign from the factory. This design (same supplier) of the HBB is relatively common on some Toyotas as well. Even the redesign systems fails at some point. They are electro-mechanical and...

what is your model year? I believe I read somewhere that in order to bleed the ABS you need to use a MUT (dealer most likely). Not sure thou. Have you consulted the FSM about the bleeding procedure?

I have a 255w 30.1V (optimum) panel that I'll be mounting to my pop-top roof soon. They are large. 65" x 39".

Whoa - a 50 amp panel would be a large suitcase. But not in jest, I use a small foldable to recharge a 24 Ah 5V Li-on bank (8 x 18650 cells) . Works great to recharge phones etc.. https://www.amazon.com/CHOETECH-Charger-Waterproof-Foldable-Compatible/dp/B00TEQJEC6

no, omg

rockers. hmu

check Mighty Max solar as well (amazon)

Curing Salt has a % of Sodium Nitrate, its listed in their ingredient list. Can't make bacon or ham without a cure. even "healthy" bacon cured with celery juice powder is just an play in advertising, because CJP contains nitrites and nitrates - but they are natural LOL. I'm fine with that...

I bought the 255 watt panel I referenced above, just wondering how big your 295 watt panels measure.

80/20 in a 1.5" x 3" profile isn't going to flex in the over hang section. I'll be overhanging 24". Not worried. Their books have bend moment calculations for every profile if you care to calc it out.

bigger roof space than the average vanagon? I'm looking at some 255 watt panels at 64.5" x 34.8". Maybe fit 2 (doubtful) on a roof? 1 on roof, 3 or 4 on side array?

This build inspired me: https://www.expeditionportal.com/forum/threads/custom-build-pop-up-camper.200540/

not sure how well that 8020 hinge system is going to work with the gasket. I believe the gasket needs a minimum gap when closed of 0.25", and the way I understand the hinge is they make are designed for no gap. I'm building something very similar as yours, opted to go with 3 aluminum standard...

Knockoffs of what? How do you create knockoffs by making loops and tying knots?

yes

Coffee should be hot brewed! (just my opinion)