Search results

What is your budget?

Your running dura tracs up front..is this 4wd?

Sold

Sold pending payment

No rack included, this is new never used. Has bed rail slides and six legs to attach a rack or cross bars $100.00 shipped

I mounted this on my swing out very heavy duty Vertical holder can not included new price $131.00 my price $80.00 shipped 1st I’ll take it gets it

I have two for sale, price is for one, fuel can NOT included. new price $ 95.00 my price is $60.00 shipped for one 1st I’ll take it gets it

Used with slimline rack for mounting a roof top tent new price $62.00 my price $35.00 shipped 1st I’ll take it gets it

Used for mounting your axe to a slimline rack new price $74.00 my price $45.00 shipped

Used for mounting hilift on slimline rack new cost $95.00 plus shippinh my price $55.00 shipped 1st i’ll take it gets it

I used these for mounting maxtax‘s on the side of the slimline rack other recovery devices might fit please check website new cost is $123.00 plus shipping. my price is $75 shipped...thats less the half with shipping 1st post ill take it, gets it!

Sold $17,250 jumped $6000 in the last minute

I didn’t see a reserve either

Mounted! I plan to fab up a set of rear door and replace the lift door and tailgate and i need to mount my kinsmen awning

@malibubts : door thickness is probally somewhat incorrect on my part it really a stiffness issue, the gasgets were good but the doors flexed and the latches did not provide even pressure. My current door are 1/8” thick and the latch is across the door so it grabs each corner. if I was looking...

One of the things I wanted were side windows in the shell, I tried to get ternbill to fit but no luck so i contacted peninsula glass and the built two to my specs. While they dont have internal shades they do have screens thus allowing air circulation what the doors looked like before I also...

Some weld info to start short tac weld I used tig but because there is 980 linear inches of weld i switched to a spool gun. Welds were 4-6 inch stitches to minimize heat distortion. Most welds were horizontal position the adapter is welded on the inside and i also used closeout angle extrusion...

What did you think about the original Snap? Been looking into Wedge Campers a bit and they are fairly local in comparison to most of the manufacturers. for what i paid in sept 2018 they were a good deal, now from the internet pricing i see i can not say that. As far as the wedge camper portion...

after I dropped the idea of removable the interface became clearer. I ordered 3”x4” x 1/4” extrusion for the main joint. One leg attaching to the bottom of the wedge to match the pickup bed and shell I tapered the other leg mounting to the shell side I shorten, corners were mitered front and...