Search results

I want a bottle of what he's drinking...

Some new ones now that I'm on the other side of the country. Putting the roof rack to the test The first time in snow with the Tundra Lots of snow in Redmond OR My old Toy the day I sold her :( I lived out of this truck for 10 days as I journeyed from Vero Beach Florida to...

They're going to throw you out of New Jersey for having such a ************ truck!

Awesome! Can't wait to see more!

Go test drive a few and find what you like. I had to wait about 2 months before I found the right Tundra, but I'm so happy I did. I'll also say go ahead and test drive a first generation Tundra, 00-06, with V8 and 4WD.

I don't know, I have Treadwright mud tires and they were like $250 cheaper than the Wrangler MTR and I love them so far. I have about 8k miles on them and they still look good as new.

Nice lookin wheels!

None of the photos show up for me. I have been wanting new UCAs to fix my upper ball joint angle after the lift, if the $600+ Uniball control arms aren't a long lasting solution, what is? Or should I just not worry so much about the stock upper control arms?

What do you think about the Timbrens now that you've had them awhile?

Water tank looks great, makes a nice flat platform too.

Looks like a factory hot rod! Very jealous

poor alignment wore two tires more than the rear tires

What's the cap made of? Mine is galvanized sheet metal and an aluminum rack.

I love a fresh set of tires, looks great!

Looking good! Always fun taking a sawzall to the truck

Made it to Burbank without further incident. I also bought a Haynes manual for future referencing.

I threw the new shaft in without too much trouble. Also found out I had a bad piston in my front caliper, it had seized and wore one of my pads out unevenly, got in to the squealer section and made the most God-awful noise. I couldn't figure it out at the time. Then I realized what it was and...

Flying the Chieftain, not even sure of the base yet. Either Oakland or Portland and i'm going to bid SLC asap. Any ideas on which CV boot I need from kartek? http://www.kartek.com/Product/DriveTrain/CV/Boots/930Boots.html I'm guessing the 930 Bates style overboot but there are a few others...

I am in the middle of moving from the south east coast of Florida to California for a new job flying cargo for Ameriflight. I am in El Paso Texas now and hope to be in Phoenix tomorrow. I have an inner CV boot on the passenger side that has torn and pretty much disintegrated. I will have a...

Powerpack looks awesome, also looks like you can charge it from a 12v DC or 120 AC source, so take your pick.