Search results

  1. J

    Diesel heater tank on frame rail?

    Purchased a Vevor Diesel heater for my Chevy Express build. I don't want a gas heater - too expensive. Ideally, I could mount some sort of fuel tank or fuel cell and install a door on the side of the van for access. However, I think I'd need a fuel filler hose to reach the side of the van...
  2. J

    Comfortable 2 Person sleeping bag recommendations for camper van

    Have a Chevy express camper / moto van. Since the bikes are hauled inside the van, the bed platform is stowed on the walls and has to be manually setup and torn down every time we set up / tear down camp. Since there's quite a few other steps involved in getting the bed setup (unload gear +...
  3. J

    Mattress & bed setups for moto van/camper setups?

    Hey folks, I'm trying to streamline the mattress setup for my Chevy express moto van. The way my van is setup, the bed platform is stowed on the walls during transit, and then when I arrive, I pull the bikes out and setup the mattress for the weekend. When the weekend is over, I tear down the...
  4. J

    DIY Fridge slide build - 1/16" aluminum angle iron strong enough?

    I'm getting started on a DIY fridge slide build for my van. I have some drawer slides on the way, and need to decide if 1/16" aluminum angle iron is sufficient or if should go up to 1/8" thick angle iron. My fridge is an older ARB 50 qt - weighs 53 lbs, plus I figure another 80 lbs if it were...
  5. J

    [Chevy Express] Adding light switches to side door area... Door jamb wire loom?

    I have a 2013 Chevy Express extended that I'm building into a moto / camper van. I want to add 3 switches to turn on 3 different sets of lights. I've identified 2 possible locations for these switches: 1. Mounted vertically, on the bottom of the B pillar on the factory trim that covers up the...
  6. J

    Awning brakcets for Chevy Express?

    Hey folks, I'd like to mount add an awning to my Chevy Express, but do not want to add a roof rack. I've seen pictures of it being done, but unfortunately the resolution isn't good enough to see who makes the brackets. Any ideas on what brackets are out there that I could use? Thanks
  7. J

    Mounting a 13" / group 31 battery to frame rail

    Is there battery box / tray that would fit a 13" wide group 31 battery? Trying to mount one or two group 31 batteries to the frame rail of my chevy express. I've searched everywhere I can think to look, and can only find trays that would fit a 11" wide group 24 battery like this one Thanks
Top