1999 Jeep Sahara TJ
- Thread starter ram2500_24v
- Start date
G0to60
Observer
What engine did you go with? Do you have any other pics during the install?
Also, I would suggest spending some time cleaning up that mess of wires and lines near the fire wall. It will make things look a lot nicer and keep them from getting pinched or rubbed through. Nice work on it though.
Also, I would suggest spending some time cleaning up that mess of wires and lines near the fire wall. It will make things look a lot nicer and keep them from getting pinched or rubbed through. Nice work on it though.
ram2500_24v
New member
It is a VW ALH code engine. I don't have many other pictures during install since I needed this done fairly quick as it is a backup vehicle for me. I completed it in my garage in about 1.5 months working only in the evenings after work. Most of the wires you see in the back driver side are the ones not used from the original 4.0 engine. I left them intact incase I ever need to go back that route. Also there is a lot of "plumbing" on these engines that make it look worse than it is. Come summer time I will remove the blue extension cord that connects my block heater which should help out.
karlmagnum
Observer
Cool. You can get plenty of power out of that motor.
Similar threads
