1st Gen tacoma switch panels

[irish_11]

I'm looking for options on switch panels, both style and mounting locations. This is for a 1st gen Tacoma. My searching has turned up plenty of 2nd gen's, FJ, and dare I say Jeeps. But I am lacking on good photos of 1st gen switch panel mounting locations and different brackets, panels and other goodies. I'm thinking 4 rocker switches, with the possibility for 6 total down the road. For now I need 2 and can think of at least 2 more. So 4 switches sounds like a good amount of thinking ahead. Anyone have a good photo or link for me?

 

[cruiseroutfit]

Are you running a single DIN or double DIN stereo? sPod had a panel that fit in the standard DIN spot if you have a single.

With a double cab you can put two under the ash-tray in the factory pop outs, one in the airbag switch blank (I put my hazard there and a ham mic holder in the hazard location). You can also sneak a few on the left side of the column.

 

[irish_11]

Thanks for the ideas. It's an extra cab with a single din stereo. I've got some stuff stored in the extra din like mp3 connector cables and what not, but I could find another place for them. That location is the spot I've been thinking works the best. Or the blank where the factory clock should have gone.

 

[slus]

I've seen them in the clock and DIN slot. Check out 12voltguy.com for ideas or to have him whip you up a panel.