2000, 100 series build

Benc

Explorer
So I was having some balance problems with the 315 Toyo at2s so after about 15k miles les schwab swapped me out for some 275/70/18s and I picked up some trd tundra wheels. The new tires measure 33.2x11 and I am really liking how the 4.88s feel with the smaller tires. I will most likely buy some more 35s to mount up on my old wheels for the harder trails.


Sent from my iPhone using TapatalkImageUploadedByTapatalk1441850050.007522.jpgImageUploadedByTapatalk1441850073.929644.jpgImageUploadedByTapatalk1441850125.442137.jpg
 
Last edited:

wingysataday

Adventurer
I'm really struggling here. I have truck listed below. I have owned since new. So many memories bla blah blah. My family is rapidly growing. My fear is missing the pickup part, having a bed to throw stuff in the back of is so nice. I only have 73k miles on my truck. I could sell it for around $22k and buy a 99-2001 100 series for 7-10k and drop 5k into it and still have 5-8k left in the bank! oh what to do....
 

ccfdcal

Observer
Got the dual batteries hooked up today! It was tricky getting 2 group 31s and the compressor to fit but it did.
ahety5em.jpg
aqeqyvy3.jpg
6ajy4yzu.jpg


Sent from my iPhone using Tapatalk

Where did you go through the firewall at? I basically did exactly what you did, however I'm struggling to figure out where to go through. I was thinking of driver side between the fender and the brake fluid reservoir.
 

Benc

Explorer
Where did you go through the firewall at? I basically did exactly what you did, however I'm struggling to figure out where to go through. I was thinking of driver side between the fender and the brake fluid reservoir.

Are you talking about the battery monitor? If so I just followed the factory wire harness and cut through the rubber boot on the driver side. Just make sure to seal up any penetrations you make.



Sent from my iPhone using Tapatalk
 

ccfdcal

Observer
Yeah that's what I was referring to. I'm going to place my fuse block in the back near my fridge so I have an additional wire to much through the firewall. It didn't seem like I had much room to go through the rubber boot on mine. I'll have to look at it again. Thanks for the input.
 

Benc

Explorer
I ran a 4ga wire through the passenger side for my aux fuse box. Hopefully you have better luck with this set up than I have had!


Sent from my iPhone using Tapatalk
 

Benc

Explorer
Hey guys,
Haven't done much to the rig lately but I have been able to get out in the fresh snow we have been having.ImageUploadedByTapatalk1452095935.009883.jpg
Future plans for the 100 are,
Custom desert tan paint with black vinyl logos on the sides with my company name, new rear bumper to match my production bumper that will be in the works soon, roof rack and new wheels and tires.
I will most like be going with the fuel anza wheels and 34x12.5r18 bfg ko2s.
Here is a pic of the wheels. ImageUploadedByTapatalk1452095793.631232.jpg

Here are some pics of some resent snow runs. ImageUploadedByTapatalk1452095850.463523.jpgImageUploadedByTapatalk1452095872.128286.jpgImageUploadedByTapatalk1452095896.619094.jpg


Sent from my iPhone using Tapatalk
 
Last edited:

Forum statistics

Threads
187,935
Messages
2,900,215
Members
229,205
Latest member
FrostyTaco
Top