2006 Nissan Xterra manual trans. with Titan swap suspension. 35” Kenda Klever R/T mounted on 17” KMC KM535 Grenade OR wheels
Drivetrain
● M205 Front Diff from Nissan Titan w/ Yukon 4.56 ring and pinion. Titan cv axles and inner/outer tie rods (Freshly rebuilt)
● M228 Rear Axle (Dana 44 equivalent) w/ Nitro 4.56 ring and pinion, ARB RD149 Air Locker and ring gear spacer from Nisstec
● Offroad Gorrilla / Ruffstuff Specialties Diff cover
Suspension, Brakes
● 2.5in Radflo coil-overs with 600lb Eibach Springs
● Alcan Custom Leaf pack +550-650lbs arched for 4” lift (w/ axle degree shims)
● Totalchaos Fabrication Titan UCA w/ uniball
● Nisstec Adjustable Shackles
● U-bolt flip kit
● Stock Titan LCA’s
● Bilstein 6253 rear shocks
● Extended Stainless Steel Braided Brake Lines (f&r)
● Powerstop Front Brake Kit (Drilled/Slotted)
● Powerstop rear Brake Kit
● PRG Heim TRE’s (don’t have picture)
Armor, Bumpers, Sliders
● Freel Good Performance Sliders w/ Kickout The body is 3/16 2x3 and the round tube is .120 wall DOM. Welded to frame.
● Front Bumper w/ hidden winch mount (1-4” Plate and 3/16”) was made with a friend of mine in his garage along with the Front skid plate (3/16”) as well.
● Rear Bumper w/ Swing Out, rear quarter guards and drop down table, hitch receiver, two recovery points and hidden rear winch mount. Holds a 5gal Wavian jerry and a swinging toolbox on the ladder
Exterior Mods
● ViAir 20020 dual 444c system (Black) underneath the truck, both air compressors installed in rear cargo area underneath drawers (accessible with seats forward and drawers pulled open).
● Diode Dynamics XP80 LED bulbs in tail lights
● Spec-D Tuning Headlights w/ Morimoto 2stroke 2.0 LED H1 bulbs
● Harbor Freight ditch light pods (they’re awesome, don’t underestimate all their products)
o Flowmaster 44 muffler and y pipe done
Recovery Gear
o Smittybilt XRC GEN3 9.5K Comp Series Winch with Synthetic Cable (additional rear winch location)
Gear Storage
o UpTop Overland Bravo Nissan Xterra Roof Rack
o Rear Drawers made built from 3/8” birch covered in outdoor marine carpet with side compartments
o Rear Seats removed and built platform for fridge and dog with storage underneath
o Raingler Nets Nissan Xterra Full Ceiling Attic Net with all the bells and whistles.
o fire extinguisher mount mounted behind feet to driver seat
Electronics, Communication, In-Cabin Accessory Mounts
o ICS Universal dash mount with RAM Mount 6” arms and quad lock mount
o Uniden CB Radio mounted to center console on passenger side
o ViAir Psi Gauge flush mounted in center console next to stickshift
o VoSwitch w/ 8gang switch controller
o Odyssey Deep Cycle Battery w/ the Rugged Rocks terminals
Tent/Awning
o CVT MT ST.Helens Aluminum shell w/ upgraded bedding, upgraded struts to carry more weight on top, four strut locks one for each strut. Has a custom one off designed roof rack for it. Used literally one time.
o CVT Awning Pioneer Series 99” with led lights
Probably forgetting some things. Axle seals and hubs/bearing assembly were done about 5k miles ago. Timing chain, chain guides and tensioners have been swapped out about 20k miles ago if that, the clutch about 6k miles ago and plugs and coils as well as alignment done very recently. I have receipts for everything and a giant binder full of all the info on the truck the parts that are on it. Can post additional pictures upon request. Have a bunch of extra parts and pieces and plumbing for front locker etc. that I’d sell with it. Last picture is how it currently sits and it has the 35” Kenda Klevers. I also have four extra spares so a complete extra set of tires. I’d take some money off if you didn’t want the tent. Flexible on price just shoot an offer.
This thing has facilitated a ton of spectacular memories for us and is more than ready to make more for you. I love this thing and would hate to see it go but thinking we may need a little more room and different setup with a growing family. Thanks for reading.
(It seems half my pictures won’t upload as they’re too big of files and I can’t figure out how to get them to upload. So I’m going to put the link to my Craigslist ad here, my apologies.. https://seattle.craigslist.org/sno/cto/d/lake-stevens-2006-nissan-xterra-t-titan/7669764063.html you may note the ad was just “testing waters” at 20k and the amount of inquiries was overwhelming)
@bbx_adventures on Instagram for more pictures as well.
The driveway picture is the most recent about a week ago.
Located: Snohomish, Wa
Asking price: $20,000
ODO: 152,313
Clean title Clean Carfax, Paid off, Title in hand
Contact: Blake.morrell1@gmail.com
Drivetrain
● M205 Front Diff from Nissan Titan w/ Yukon 4.56 ring and pinion. Titan cv axles and inner/outer tie rods (Freshly rebuilt)
● M228 Rear Axle (Dana 44 equivalent) w/ Nitro 4.56 ring and pinion, ARB RD149 Air Locker and ring gear spacer from Nisstec
● Offroad Gorrilla / Ruffstuff Specialties Diff cover
Suspension, Brakes
● 2.5in Radflo coil-overs with 600lb Eibach Springs
● Alcan Custom Leaf pack +550-650lbs arched for 4” lift (w/ axle degree shims)
● Totalchaos Fabrication Titan UCA w/ uniball
● Nisstec Adjustable Shackles
● U-bolt flip kit
● Stock Titan LCA’s
● Bilstein 6253 rear shocks
● Extended Stainless Steel Braided Brake Lines (f&r)
● Powerstop Front Brake Kit (Drilled/Slotted)
● Powerstop rear Brake Kit
● PRG Heim TRE’s (don’t have picture)
Armor, Bumpers, Sliders
● Freel Good Performance Sliders w/ Kickout The body is 3/16 2x3 and the round tube is .120 wall DOM. Welded to frame.
● Front Bumper w/ hidden winch mount (1-4” Plate and 3/16”) was made with a friend of mine in his garage along with the Front skid plate (3/16”) as well.
● Rear Bumper w/ Swing Out, rear quarter guards and drop down table, hitch receiver, two recovery points and hidden rear winch mount. Holds a 5gal Wavian jerry and a swinging toolbox on the ladder
Exterior Mods
● ViAir 20020 dual 444c system (Black) underneath the truck, both air compressors installed in rear cargo area underneath drawers (accessible with seats forward and drawers pulled open).
● Diode Dynamics XP80 LED bulbs in tail lights
● Spec-D Tuning Headlights w/ Morimoto 2stroke 2.0 LED H1 bulbs
● Harbor Freight ditch light pods (they’re awesome, don’t underestimate all their products)
o Flowmaster 44 muffler and y pipe done
Recovery Gear
o Smittybilt XRC GEN3 9.5K Comp Series Winch with Synthetic Cable (additional rear winch location)
Gear Storage
o UpTop Overland Bravo Nissan Xterra Roof Rack
o Rear Drawers made built from 3/8” birch covered in outdoor marine carpet with side compartments
o Rear Seats removed and built platform for fridge and dog with storage underneath
o Raingler Nets Nissan Xterra Full Ceiling Attic Net with all the bells and whistles.
o fire extinguisher mount mounted behind feet to driver seat
Electronics, Communication, In-Cabin Accessory Mounts
o ICS Universal dash mount with RAM Mount 6” arms and quad lock mount
o Uniden CB Radio mounted to center console on passenger side
o ViAir Psi Gauge flush mounted in center console next to stickshift
o VoSwitch w/ 8gang switch controller
o Odyssey Deep Cycle Battery w/ the Rugged Rocks terminals
Tent/Awning
o CVT MT ST.Helens Aluminum shell w/ upgraded bedding, upgraded struts to carry more weight on top, four strut locks one for each strut. Has a custom one off designed roof rack for it. Used literally one time.
o CVT Awning Pioneer Series 99” with led lights
Probably forgetting some things. Axle seals and hubs/bearing assembly were done about 5k miles ago. Timing chain, chain guides and tensioners have been swapped out about 20k miles ago if that, the clutch about 6k miles ago and plugs and coils as well as alignment done very recently. I have receipts for everything and a giant binder full of all the info on the truck the parts that are on it. Can post additional pictures upon request. Have a bunch of extra parts and pieces and plumbing for front locker etc. that I’d sell with it. Last picture is how it currently sits and it has the 35” Kenda Klevers. I also have four extra spares so a complete extra set of tires. I’d take some money off if you didn’t want the tent. Flexible on price just shoot an offer.
This thing has facilitated a ton of spectacular memories for us and is more than ready to make more for you. I love this thing and would hate to see it go but thinking we may need a little more room and different setup with a growing family. Thanks for reading.
(It seems half my pictures won’t upload as they’re too big of files and I can’t figure out how to get them to upload. So I’m going to put the link to my Craigslist ad here, my apologies.. https://seattle.craigslist.org/sno/cto/d/lake-stevens-2006-nissan-xterra-t-titan/7669764063.html you may note the ad was just “testing waters” at 20k and the amount of inquiries was overwhelming)
@bbx_adventures on Instagram for more pictures as well.
The driveway picture is the most recent about a week ago.
Located: Snohomish, Wa
Asking price: $20,000
ODO: 152,313
Clean title Clean Carfax, Paid off, Title in hand
Contact: Blake.morrell1@gmail.com
Attachments
Last edited:
