2006 Project TJ

[Daz7]

I've been looking at Auxiliary battery systems for the TJ and ended up buying a portable unit.

 

[Daz7]

Went out with Sydney Jeep Club on the weekend, a really nice day was had!

 

[Daz7]

Where I source my parts from

 

[Daz7]

Found out there was a firmware update for the Alpine Halo 9 unit. This is how you do the update.

 

[Daz7]

Fitted up my 67 designs mounting system today - chuffed!

 

[Zeep]

Those are very nice mounts.
I'm sure you already have a lot invested in your Alpine head unit. But I was wondering if you knew about this?
http://www.metraonline.com/part/95-6541

 

[Daz7]

Yes, know all about the 2din facia, look I'm not a fan.

The Halo unit doesn't need any behind dash material removed, whereas the 2din versions do, I also prefer the larger screen of the Halo over the 2 din versions and the fact that it's higher and I don't have to look down whilst driving to use it. Personal preferences and all that.

 

[Daz7]

I've had a bolt fall out of the rear tailshaft's saddle. As a result, the tailshaft ended up on the road. This is the repair.

 

[Zeep]

Not to pile on to your problems, but it looks like your pinion seal needs some attention!

 

[Daz7]

Not to pile on to your problems, but it looks like your pinion seal needs some attention!

Yep, will all be sorted with a regear and lockers.

 

[Daz7]

Just installed a set of Corbeau Seat Heaters - Toasty!

 

[Daz7]

Have an issue with a low oil pressure warning at idle

 

[Zeep]

Glad you researched that problem first. Sucks, that a gauge is really just a fancy idiot light!
I wonder if just flushing the old sender with solvent, could have made it work again?
Anyway, Cheers to getting it done.

 

[Daz7]

Starting to prepare for the ARB Air Lockers. In this episode I tackle the under bonnet fitting and wiring of the ARB Air Compressor to the sPod unit.

 

[billiebob]

Have an issue with a low oil pressure warning at idle

Same problem, mine started 2 weeks ago. jeep spec says minimum is 13psi, with a mechanical gauge at idle it registers 10psi. No solution yet.
But since you are now adding an air compressor I take it you solved the oil pressure issue ?

We replaced the sender today too but no difference, maybe even worse since the new sender .... is new.
The video is a complete waste of time.