Aircraft track Tie Downs

[ssssnake529]

I installed those things in my Cruiser. I used JB Weld. Works fine.

 

[MotoDave]

Thought I'd update this thread with my install into my new tundra: http://www.expeditionportal.com/for...ra-Bed-Rail-Alternative?p=1177382#post1177382

 

[KaiserM715]

This is what I installed:

It is a little hard to see. I installed two 4' tracks in the bottom of the bed and one 1' track on each side in the back.

Here is a link to my write-up:
http://www.fordraptorforum.com/f11/cargo-rail-install-12218/

 

[TEJASYOTA]

I have MAC for my Tacoma, not the rail version.
I picked MAC for the all metal requirement for exposed environment use.

No plastic will last for many years in exposed sun light, even with UV stabilizers molded with the plastic.
I know, I'm a plastic engineer.

So if you do get those costo version, make sure they are used inside your vehicle.

 

[rb70383]

More ideas. Would these rails work as the roof rails for a roof rack? Could be a very nice very flexible roof rack rail system. Just not sure about dirt and debris getting into the track.

 

[HillbillyfromAL]

No reason they couldn't be used on a roof rack. The ones I have are Aluminum so no worries about rust. Just make sure to use stainless hardware.