sunchaser365
New member
I just installed a landed on my Keystone camper made from a upside down frame hitch. I then attach the new hitch to my existing hitch using two. 2 inch ball mounts using the ball to attach the unit together. After that i installed a 36 inch 2x10 piece of board with skid tap. The final thing was to use 2 turn buckles at each end to stabilize the landing that is 5 inches lower than the camper floor. I went out and purchased a 2 step plastic stool from HD that I keep inside the camper until needed.
I hope this might help someone getting in and out of their camper.
Sunchaser365
I hope this might help someone getting in and out of their camper.
Sunchaser365
