Ford E350 Disable Backup Sensor Error Message

[mwslaughter]

I replaced the factory bumper on my 2014 E350 with the Ujoint Offroad Rear Bumper, thereby disconnecting the rear parking sensors. I am trying to disable the error message that I get every time I back up. The PAM module in Forscan shows one setting 736-01-01 0140, where the "0140" is the editable part of the code. Does anyone know what change is required here to disable the error message? Are there any other settings that need to be changed? Any help is greatly appreciated.

 

[86scotty]

I hope you figure this out. Please post if you do.


Sent from my iPhone using Tapatalk

 

[mwslaughter]

I just got this advice, will try it this weekend and let you know if it works.

"Go into the IPC and on line 720-01-01 enter 6A203X226C4D"

 

[mwslaughter]

Ok, so I entered the code as directed in the IPC Module 720-01-01 [6A20 3X22 6C4D] and Forscan gave me a warning message about checksum error. I clicked OK to just override the error, then I clicked "Write". Once it finished, the program altered the code to [6A20 226C 4D8E]. I really don't know what happened or why, but the end result is what I wanted and the error message is now gone so I am just going to leave it here.

If you try this at home, make sure to write down the default code so you can put it back together if it doesn't work for you the way it did for me.