Horn Button

[Steve Curren]

I have a Jeep JK and I am putting another horn on it, I want to keep the stock one as well. My question is does anyone know of a good looking button I can use for the horn, I would like it about an inch and a half across or less and the whole thing to be as flat as possible. I am planning on putting the button on the forward face of the center console.
Thanks,
Steve

 

[truck mechanic]

Go to any Napa store and tell tem you want a surface mounted horn button, they will most likely have them in stock

 

[Steve Curren]

Thanks so much for your answer, I will check it out and soon be blowing my horn..

 

[JJackson]

Does the dash have unused accesory switch hole like some Toyota's? If so you could find a stock appearing switch/button to use.

 

[HenryJ]

Looks like my post was lost?

What about adding a switch to alternate between horns or combine them and use the stock horn button?

Intercept the horn activation wire and add a switch "on-on" or "on-both-on"

Add another relay and horn then you are good to go. I like the idea of not having to reach for a horn button when the need arises.

 

[Steve Curren]

I guess with proper supervision I could switch between the horns, I like the idea becasue I am a tad worried about the noise. This electric air horn has a nice loud volume and I would not like the locals to start a cite. Also as stated I am a bit concerned about reaching for a button but I didn't think about a switch. I would love to mount the speaker on the bumper but then I am sure that I would draw attention.
Thanks to all for their help...