While I don't have an Explore, the answer is still the same. The simple answer is yes, you can do a 1 for 1 swap and everything still work just fine. However, you won't be fully charging your battery. A lithium charges at a higher voltage than a lead acid/agm. So your current charger in its current state won't fully charge it. If the charger/converter you have is new enough, it may have an internal switch for lithium batteries. If it does, it will be labeled as such. If not, you'd need a new charge controller or dedicated battery charger.
I have a Smittybilt generator that I use. It's 2600 max / 2300 continuous. I did add a soft start to the A/C because the compressor wouldn't start every time. Now it works great.
I suspect they are near capacity and are not interested in low volume custom work
Perhaps you could employ a local steel fab shop to produce a weldment to replace the Cast a-frame hitch. Could even use the same bolt holes.
I would want the end of the tongue to be like this from the factory. Is there a reason why you only offer a traditional ball mount? Most off-road folks want a Max Coupler, Lock-N-Roll or similar on their trailers. I'll take a look at one of your trailers in person later in the week.
Thanks,
Chris
If it is lashing down rain and sleet while you are packing up, does any wetness trasfer onto the inside? IE will the bedding get wet? This is a problem on my Rockwood 1640 esp
