emt.micah
Observer
So I wanted to install one of these inverters in my JK.
http://www.menards.com/main/tools-h...ssional-installation-kit/p-1962853-c-9100.htm
It's an 800W inverter with a really sweet remote panel with USB, 2x 110 outlets and an on/off switch for the whole thing.
Plan was to mount this under the passenger seat, and put the remote panel on the front tide of the center arm rest, up above the parking break.
The problem is that for a 6' cable run, it says I need to use 2ga wire. Now just how the hell am I going to run 2x 2ga wires from under the passenger seat to the battery. No frackin way they'll run through the pass thru that everyone uses at the base of the A pillar.
Suggestions?
Micah
http://www.menards.com/main/tools-h...ssional-installation-kit/p-1962853-c-9100.htm
It's an 800W inverter with a really sweet remote panel with USB, 2x 110 outlets and an on/off switch for the whole thing.
Plan was to mount this under the passenger seat, and put the remote panel on the front tide of the center arm rest, up above the parking break.
The problem is that for a 6' cable run, it says I need to use 2ga wire. Now just how the hell am I going to run 2x 2ga wires from under the passenger seat to the battery. No frackin way they'll run through the pass thru that everyone uses at the base of the A pillar.
Suggestions?
Micah