Jeep to F150 HD SCREW...
- Thread starter wanabxtrm
- Start date
Yup, that's what sitting on top of the winch, sync line and extension. Based on the 'highly' I'm guessing there's a story there...
I've seen and heard both style lines snap during boat tow operations, though that was the older style nylon lines, not the newer spectra/dyneema. Both scenarios are bad news, especially at higher towing force levels.
Sent from my iPad using Tapatalk
Drawer & storage.
Families out of town so I got cranking on some storage. It's not done yet needs a lot of finish work but is usable and that's usually where I end up stopping in the end with most projects. Still trying to figure out what to do for nonskid for the dog. Weighing options of:Roll on bedliner, restore deck finish, garage rubber flooring, or horse stall matting, I prefer the latter but depending on price and weight I may end up with paint.
(Don't know how to rotate on here)
Some storage in the wheel wells on either side, 60 inch slide out drawer, and foot well for the bicycle or otherwise storage with the top on it. Still has a full 4 feet for sheet goods, and I can still sit upright underneath the roof.
All told about three sheets of plywood, Half a jar of wood glue, Lots of swearing over the F1 50s various humps in the bed, one really expensive drawer slide and A few days sweat equity; but I think it'll be worth it in the end. I'll try to upload some more pictures later on.
Families out of town so I got cranking on some storage. It's not done yet needs a lot of finish work but is usable and that's usually where I end up stopping in the end with most projects. Still trying to figure out what to do for nonskid for the dog. Weighing options of:Roll on bedliner, restore deck finish, garage rubber flooring, or horse stall matting, I prefer the latter but depending on price and weight I may end up with paint.
(Don't know how to rotate on here)
Some storage in the wheel wells on either side, 60 inch slide out drawer, and foot well for the bicycle or otherwise storage with the top on it. Still has a full 4 feet for sheet goods, and I can still sit upright underneath the roof.
All told about three sheets of plywood, Half a jar of wood glue, Lots of swearing over the F1 50s various humps in the bed, one really expensive drawer slide and A few days sweat equity; but I think it'll be worth it in the end. I'll try to upload some more pictures later on.
Last edited:
Figured I’d drop a line back here since I’ve been perusing the forum recently. Almost talked myself into an upgrade to a tremor but fiscal realities brought me to my senses.
Just about 60k on the F150 with no complaints!
Spent some time upgrading my rack recently to support our summer trips now with COVID around; and finally got around to painting my drawers and running power to the bed. I’ll drop a photo or two here if it’s ever clean enough to show off. The awning is sweet and definitely a nice upgrade; and the Thule ski racks work great (after some diy mods to make them fit)
Tempted to upgrade the suspension, and swap my topper for a 4 wheel camper project M; but for now it’s a pretty sweet setup. As an old time friends wife stated ‘my husbands jealous’.
Cheers!
Just about 60k on the F150 with no complaints!
Spent some time upgrading my rack recently to support our summer trips now with COVID around; and finally got around to painting my drawers and running power to the bed. I’ll drop a photo or two here if it’s ever clean enough to show off. The awning is sweet and definitely a nice upgrade; and the Thule ski racks work great (after some diy mods to make them fit)
Tempted to upgrade the suspension, and swap my topper for a 4 wheel camper project M; but for now it’s a pretty sweet setup. As an old time friends wife stated ‘my husbands jealous’.
Cheers!
D
Deleted member 9101
Guest
Easiest way is to get an intercooler that mounts above the stock location.
Oooooor you could run any aftermarket intercooler that is larger/more efficient than the craptastic stock one to offset the loss in airflow from the winch. Considering Ford will put a license plate over the hole for the intercooler, I'm thinking there is plenty of airflow remaining.
High-Performance Intercoolers for Enhanced Automotive Efficiency
Intercoolers - Performance Automotive Products | Vivid Racing
www.vividracing.com
Got a rattle coming from the torque converter that showed up in the last few weeks. Originally thought it was a condensate issue with the turbos but dealer says tranny. Covered under warranty.
Ordered some new shocks for the rears; bilstien 5160’s. And finally cleaned up the rear drawer system and power run for the bed.
Awnings been great definitely recommend it.
Ordered some new shocks for the rears; bilstien 5160’s. And finally cleaned up the rear drawer system and power run for the bed.
Awnings been great definitely recommend it.
Martinjmpr
Wiffleball Batter
Listed for sale... upgrading to an F350...
expeditionportal.com
Rare special order: 2016 Heavy Duty Payload F150 FX4 Crew Cab
Location DC region. Reason for sale: upgrading to an F350 Tremor to accommodate the growing family (and associated stuff). Asking $36000. Already have a trade offer so fairly firm on price but willing to have a conversation. Includes Snugtop topper; Rack/shelving is planned to be moved to...
expeditionportal.com
phsycle
Adventurer
Listed for sale... upgrading to an F350...
Rare special order: 2016 Heavy Duty Payload F150 FX4 Crew Cab
Location DC region. Reason for sale: upgrading to an F350 Tremor to accommodate the growing family (and associated stuff). Asking $36000. Already have a trade offer so fairly firm on price but willing to have a conversation. Includes Snugtop topper; Rack/shelving is planned to be moved to...
Nice deal. Rare bird and optioned exactly how I would if I custom ordered. Paging @Todd n Natalie
Todd780
OverCamper
Haha! why paging me?
phsycle
Adventurer
I thought you were looking for a HDPP. And a Ranger. And an F250. And..... ?
Todd780
OverCamper
Yeah, I don't know what i want, lol.
Something smaller / cheaper like a Ranger would be nice to be more fuel efficient, could fit in the garage etc. Just don't know that it will fit the bill for kids / towing / hauling.
I like the F250 for payload. HDPP Seems like a good in between compromise.
I've got lots of time though. I'm in no rush.
That HDPP looks nice but, my truck is only a year older with 40K more miles. So, not gaining a whole bunch. Plus when you convert CDN pesos to USD, I think that truck would cost me $364,096.00.
EDIT: I also want a Power Wagon, a Gladiator, a Bronco, a Raptor, a TRX, a 200 series Land Cruiser a E39 M5, Porsche 718 and a '58 Plymouth and and........
Last edited:
Similar threads
