Just got back from days off and dove into the rear diff breather extension. I apologize ahead of time to the person who's idea I stole for where to mount the breather, but I loved it!
I started by pulling the rear fender down and gauging where I could run the lines without putting a kink in the line. I then drilled the hole where the breather tip will sit.
I then filed, prepped and painted both sides of the hole I just made.
The old breather was rusted and partially smashed but thankfully the old one spun out and new brass barb fitting went in just fine.
I'm only temporarily running the line this way until I can find a correct size grommet to run the line through the bed cross member instead of zip tied along side it.
The new breather in it's new home!
Again, thanks to whoever on the forum I got the idea from!
I started by pulling the rear fender down and gauging where I could run the lines without putting a kink in the line. I then drilled the hole where the breather tip will sit.
I then filed, prepped and painted both sides of the hole I just made.
The old breather was rusted and partially smashed but thankfully the old one spun out and new brass barb fitting went in just fine.
I'm only temporarily running the line this way until I can find a correct size grommet to run the line through the bed cross member instead of zip tied along side it.
The new breather in it's new home!
Again, thanks to whoever on the forum I got the idea from!