My 4x4 Red Cross ERV Build and Adventures
- Thread starter Rebuilder
- Start date
Rebuilder
Builder of Things That Interest Me
It's holding up great. Zero problems with it and I use the lift daily when I'm on trips. I always drive around with the bed up and only lower it for sleeping. Wouldn't change a thing.
Rebuilder
Builder of Things That Interest Me
Just remembered someone also asked how the awning is holding up. It's been working great but I haven't learned to trust it being fully self supporting so I usually retract it if the wind picks up at all. I have plans to make some adjustable supports to triangulate it back to the camper but haven't got around to it yet.
I actually have a lot of updates to add to this build thread when I get the time.
Short list is.....
I've rebuilt the rear axle again to add the integrated e-brake to replace the one that was removed when installing the transfer case and I also installed an ARB locker.
I fixed the VSS issue by modifying the T Case output shaft and housing to accept the OEM gear driven speed sensor because I couldn't get anything else to work.
Also replaced the Chinese hydronic heater with an Espar unit after the Chinese unit heat sensor failed.
I actually have a lot of updates to add to this build thread when I get the time.
Short list is.....
I've rebuilt the rear axle again to add the integrated e-brake to replace the one that was removed when installing the transfer case and I also installed an ARB locker.
I fixed the VSS issue by modifying the T Case output shaft and housing to accept the OEM gear driven speed sensor because I couldn't get anything else to work.
Also replaced the Chinese hydronic heater with an Espar unit after the Chinese unit heat sensor failed.
SnowCarver
New member
Can you tell what your supply and return temps are on your hydronic boiler?
Rebuilder
Builder of Things That Interest Me
I'll check next time I fire it up.
SnowCarver
New member
Thanks, mine seem low but I don't know what is typical.