New OME 762 Springs - One HIGH Corner

[t42beal13t]

I just wrapped up installing new OME 751 and 762 springs. Three corners look great but the rear left corner, with spring marked 762A, is sitting a good two inches higher than the others. I triple checked that the spring was seated properly and I can't find any reason for this corner to be sitting so high. Any insight?

 

[luckyjoe]

Two options, swap rear springs left & right, OR, swap front springs left & right.

Did you take measurements with your previous springs installed? Did you have a low or high corner?

 

[t42beal13t]

I didn't have a high corner before running RTE 3" springs so I don't see how swapping springs around would help.

I didn't measure but visually you can tell it went from being level in the back to a few inches higher in the left rear after the new springs went in.