98tcoma3rz
Observer
I bought some OME dakars about a year and a half ago. I have the add a leaf installed as well. I have a fiberglass cap and swing out tire carrier. I know the tacomas have the "taco lean" but mine seams really bad. When I initially installed them I turned up the driver's side coil over about an inch and 1/8 more than the passenger side to level the rear. I recently installed the add a leafs and while doing so I noticed the 2 bottom overload leafs are MUCH more negatively arched than the passenger side. Also the driver side is still sitting a bout a half inch lower than the passenger side. Is this normal? Should I email ARB about the issue? My main concern is that the left side overloads are much more arched (negatively). Here are a couple pictures of the truck on a lift (springs are not compressed)
![20160227_184702-min.jpg 20160227_184702-min.jpg](https://expeditionportal.com/forum/data/attachments/256/256150-8799ab8c1de669c705d50e35d598cc82.jpg)
![20160227_184709-min.jpg 20160227_184709-min.jpg](https://expeditionportal.com/forum/data/attachments/256/256152-27d1c85cc560cd4301df5947495efe11.jpg)
![20160227_184702-min.jpg 20160227_184702-min.jpg](https://expeditionportal.com/forum/data/attachments/256/256150-8799ab8c1de669c705d50e35d598cc82.jpg)
![20160227_184709-min.jpg 20160227_184709-min.jpg](https://expeditionportal.com/forum/data/attachments/256/256152-27d1c85cc560cd4301df5947495efe11.jpg)
Last edited: