Just wanted to add to the knowledge base.
If your compass backlighting goes dark...

...you will need 2 of these. You can buy them from the dealer.

Pry off both plastic screw caps on either side of the gauge cluster hood and unscrew both screws.

Remove gauge cluster hood.

Remove 4 screws attaching gauge housing to dash.

Lift gauge housing and disconnect wiring connector.

Flip housing over and unscrew 2 lower (outer) and 2 upper screws to separate gauge housing from dash trim.

CONTINUED IN POST #2...
If your compass backlighting goes dark...

...you will need 2 of these. You can buy them from the dealer.


Pry off both plastic screw caps on either side of the gauge cluster hood and unscrew both screws.

Remove gauge cluster hood.

Remove 4 screws attaching gauge housing to dash.


Lift gauge housing and disconnect wiring connector.

Flip housing over and unscrew 2 lower (outer) and 2 upper screws to separate gauge housing from dash trim.


CONTINUED IN POST #2...
Last edited: