I’m selling an Access Mfg Tradesman camper shell. It is for an 8ft truck bed and should work on most trucks with a full sized bed. Carpeted interior, sliding screen windows and double doors in the rear. Very lightweight. This is great for overlanding, dirt bikes, and even snowmobiles. Has one small leak that would be fixed with some silicone and the rear doors could use a little work. These go for over $6000 new. Dimensions listed in pics. Located in Steamboat Springs, CO
SOLD. Tradesman Cabover Camper Shell ($1500)
- Thread starter alexauch
- Start date
Skinhyfish
Observer
What was it on before? How high from bottom of overhang down?
Previously on a dodge 2500. I’m not sure if that dimension but can get it
billiebob
Well-known member
Just tell us the year. The cabs got taller in 2004???
24.5”
24.5”
billiebob
Well-known member
What year Dodge 2500 ?
Not sure, the guy I bought it from had it on 3 different trucks and it worked on all of them. I have a 1st gen tundra that has a much narrower bed so it doesn’t fit
BigJimCruising
Adventurer
This might help. I have a new Ram 3500 8ft bed. I just went and measured and that 24.5 inch height will NOT clear the roof of my cab. Looks about an inch too short. It might just clear the roof (doubtful I don't have a straight edge handy) but will certainly hit the lights and antennas.
You could always just shim up the bedrails a bit with ply or 2x4
chris_the_wrench
Fixer & Builder of Things
No plans as of now