Swingout fabrication needed in Phoenix Saturday April 2nd

JeepTreeHouse

Adventurer
Hello fellow expo members,

Sorry the title may be a bit confusing. We are currently on a cross country expedition trip from Maryland to the four corners area and back.

Before leaving on the trip I just finished up the truck for our travels. One thing that was done was installing a tire hoist to hold my 315 (35")spare on my 01 4runner in the stock location. The piece was built by Sonoran steel and works great. The only problem is that it did not work as expected with my custom rear bumper. Now my spare hangs too low in my opinion, and I would like to remedy this before any serious off roading in AZ and UT.

aefde379-3625-36dc.jpg


So I am currently in Albuquerque NM, and plan to be in the Scottsdale area by Friday night. Are there any fabricators that could tackle building a swing out onto my bumper in such short notice? And on a Saturday?
 

MTDewX8

Observer
best of luck on your trip. sounds like a blast. dont know of any down there, but I do know some good guys in Idaho falls that go under the name CBI.

but that is a little farther north I presume you are going.

have a good trip


ps. they do have these cool hitch mounted tire racks that you can put on to carry gas cans, spare and Hi-lift. maybe they could ship it some where close to where you will be. just a thought.
 
Just saw this and am not sure if you found anybody or not. I am probably late but if not give Ian at rpm fab a call 480-329-2992. Tell him Casey with the Teryx told you to call.
 

Forum statistics

Threads
190,272
Messages
2,925,796
Members
233,644
Latest member
4xCoffee
Top