Rogue Overland
New member
Hello all !
You will have to forgive me as I am not always active on the forums but I wanted to share the build on my 2012 Nissan Xterra Pro4X. My goal with this build, which I have done myself since purchasing new in 2012, was to build the ultimate combination of an expedition ready / rock-crawling go-anywhere I want rig
If you would like to follow the adventures on Instagram we are @ RogueOverland
My Photography page is @VegasVuk
The Build List:
Front Suspension:
Rear Suspension:
Drivetrain:
Powertrain:
Electronics:
Lighting:
Wheels/Tires:
The Armor:
Exterior Gear:
Recovery Gear:
Interior:
Misc:
Thanks for reading !
-Andrew
http://www.rogueoverland.com
http://www.andrewjphoto.com
You will have to forgive me as I am not always active on the forums but I wanted to share the build on my 2012 Nissan Xterra Pro4X. My goal with this build, which I have done myself since purchasing new in 2012, was to build the ultimate combination of an expedition ready / rock-crawling go-anywhere I want rig
If you would like to follow the adventures on Instagram we are @ RogueOverland
My Photography page is @VegasVuk
The Build List:
Front Suspension:
- Titan Swapped
- PRG Upper Titan Control Arms
- Factory lower titan control arms custom boxed
- SAW Race Runners w/ Eibach 650lb springs
- Sway bars removed
- PRG outer heim tie rods w/custom inner tie rod
Rear Suspension:
- Alcan 3.5" + 650lb rear leaf packs
- Bilstein 5125 rear shocks
- Sway-bars removed
- Nisstec rear shock protectors
- Nisstec U-bolt flip kit
- Custom modified timbren bump-stops
- Extended brake lines w/custom e-brake cable mount
Drivetrain:
- 2012 M205 Front Differential w/ ARB Air Locker
- 5.13 Re-gear
- M226 ARB Air Locker with custom D44 axle shafts
- ARB nodular iron rear diff cover
- Dan's driveline custom made double carden rear drive shaft using spicer 1310's
- Custom made front driveshaft
- Factory nissan titan front CV-Axles
- JWT Performance clutch and Flywheel
- PRG Short-Shift Kit
Powertrain:
- Bully dog tuner
- Borla Stainless cat-back exhaust system
- Airflow snorkel w/Volant modified air box (fully sealed system)
- Airaid TB spacer
Electronics:
- Dual battery system using the following components
- Optima red-top
- Oddessy gel cell motorcycle battery
- battery isolation switch w/monitor
- dual rear-vehicle mounted battery posts w/gauge
- rear Edison power strip accommodating an additional 150amps w/usb output
Lighting:
- Aurora roof mounted 30" LED Bar
- Amazon 20" curved front bumper mounted LED bar (downgraded 08/2017)
- OffroadGorilla LUX Rock Lights x 4
- Amazon specials led cube rear bumper mounted LED's
- ZAMP Solar LED Awning light bar kit
Wheels/Tires:
- Level 8 Motorsport 16" Bully Pro Wheels
- 315/75/16 (35") BFGoodrich K02 All-Terrain ( Added 05/2018)
- Spidertrax 1.5 " Wheel spacers
The Armor:
- Hefty Fabworks Front and Rear Bumpers
- Hefty Fabworks rock sliders
- Hefty Fabworks full aluminum skid plates
- Custom built rear corners that tie into the frame utilizing 1" .120 wall tubing all custom bent and welded
Exterior Gear:
- GOBI stealth series roof rack
- GOBI rear ladder
- CVT Mt. St. Helens Hardshell Tent ( UPGRADED 08/2017)
- ARB 79" Awning
- Custom mount ROTOPAX setup allowing for 10 gallons of fuel and 6 gallons of water to be carried
- Trash A ROO !
Recovery Gear:
- Smittybilt 10k X20 Winch with/syn line
- Factor 55 Pro-Link
- MaxTrax x2 / Bubba Rope !! (Added 08/2017)
Interior:
- Custom interior storage system
- raingler netting
- OBA unit w/compressor
- Sweet LED lighting
- ARB 63L Fridge w/slide
Misc:
- No body Lift
- Btech 2m Radio w/Diamond h770b whip
- CB Radio w/firestik whip
- Lots of love and money
- OverlandSolar 60W System (05/2018)
Thanks for reading !
-Andrew
http://www.rogueoverland.com
http://www.andrewjphoto.com
Last edited:
