Stoffregen Motorsports
Explorer
For Sale - 4.0L 1GR-FE V6
Engine was used for mock up only and is rumored to have internal engine damage. Make Offer.
Intake plenum is a twin to the one I built for "Superrunner" a few year back. It was machined by Inchworm Gear owner Jim Christiansen and was designed to replace the stock plastic Tacoma intake plenum. These are only the billet pieces, and fabrication will be required to install it, but if you've got an imagination and a TIG welder... Asking $500 for both pieces. Original machine cost was over $3000 for two of them.
Contact me through the forum or at stoffregenmotorsports@gmail.com
Engine was used for mock up only and is rumored to have internal engine damage. Make Offer.
Intake plenum is a twin to the one I built for "Superrunner" a few year back. It was machined by Inchworm Gear owner Jim Christiansen and was designed to replace the stock plastic Tacoma intake plenum. These are only the billet pieces, and fabrication will be required to install it, but if you've got an imagination and a TIG welder... Asking $500 for both pieces. Original machine cost was over $3000 for two of them.
Contact me through the forum or at stoffregenmotorsports@gmail.com