What did you do to your Expo Jeep today?

[RESQNU]

My '07 JKU

I added a custom wiring distribution center to the security enclosure in the back for all of my current and future accessories. I used two Radio Shack prjoect boxes, stainless hardware, spacers, wiring conduits, 12v fuse blocks and wiring terminals.





I will be adding wire loom to cover the visible wiring seen here.

 

[e-jeep]

Been a while since I signed on, so in the last few months:

Teraflex D44 front axle
Shrockworks rear bumper; jerry can holders; cargo basket
Dropped her down from 3.5" to 1.5" Rock Krawler coils
35" Nitto Trail Grapplers
AEV Pintler Beadlocks
Synergy tie rod/ball joints
Spidertrax 1.5" wheel spacers

 

[mmaattppoo]

Content removed in protest of discontinuation of Tapatalk support.

 

[lysol]

Looking good Lysol

Thanks Rich! I have to remove the battery mount to grind down a small section of it. It's touching the side of the hard top which I don't like. Other than that, not much else happening in the way of the expo jeep. We owe on taxes this year and have to pay them off first... I'm pretty sure I'm going to have to get a refund on the Expo tickets and put off getting the Gobi rack...

 

[JPsLC]

I washed it and cleaned-up the inside for the first time in two years then went on a 1000 mile trip to the Texas hill country. I clocked 250,000 miles on the odometer while driving every obscure road we could find!

 

[jpat30]

Congrats on 250K JP and heres to another 250K!

 

[Yarjammer]

I said goodbye to hood flutter!

 

[TreeTopFlyer]

View attachment 209999

Regency Bridge. Thats a cool route. Did it a few years back with a group. I got the excursion weighed just to be on the safe side. I was clocking in at around 9300lbs. The bridge was bowing a little as I went over.

 

[Jakes01234]

I made a new air manifold for my lockers and general use airlines.

Sent from my DROID RAZR using Tapatalk

 

[jpat30]

New Decal

Representing....Just got my new Portal decal on Big Thanks to HeeHawHardy for the hook up!

 

[expedition4x4]

Reinstalled my Vector e-dock for my 2012 jk


So I originally followed directions for the e-dock and had doubts that it would not rattle. I was correct as the dock uses double sided tape and one small bolt in bottom with hard rubber standoffs to "wedge" into the top tray spot and rattled or squeaked a bit after mounting my 8" windows tablet and radio head.

So since I had been wanting to reroute power to the top anyways I took the Dash piece out and fastened the dock to the dash using 4 m4 bolts with washers and a softer rubber standoffs. I also used a 3/4" grommet for cables.

 

[udoxx]

Expedition4x4 what mapping software do you use?

 

[expedition4x4]

Overland Navigator, a supporting sponsor of the forum

 

[Jkfisher84]

Ordered a yeti cooler for the back from the group buy WHOO HOO

 

[WininUtah]

I happened to see that Outback Adventure had a "Superbowl Sale" on the Trailgater. I even got personalized delivery, Doug came by with the table. Spent sometime talking Utah, always fun. The install was really easy, haven't gone off road but it seems very secure, no rattles.

Win