Hi,
I just purchased a used Ford e-350 van that has some sort of a custom bumper.
I found a hole approximately 2 inches in diameter, and about 5 1/4" deep before it begins to taper off smaller.
I'm trying to figure out what my options are in terms of installing a swing arm. I'd like to do a full size swing arm to store some extra gas tanks if possible.
Is a swing arm possible with this existing hole? Will I need to go with a custom fabricated solution?
Here is a picture:
I just purchased a used Ford e-350 van that has some sort of a custom bumper.
I found a hole approximately 2 inches in diameter, and about 5 1/4" deep before it begins to taper off smaller.
I'm trying to figure out what my options are in terms of installing a swing arm. I'd like to do a full size swing arm to store some extra gas tanks if possible.
Is a swing arm possible with this existing hole? Will I need to go with a custom fabricated solution?
Here is a picture: