tbock7117
New member
I'm reattaching the tent to my FlipOac a curious if anybody has done this or know the steps that were taken at the factory?
For instance:
- should I put the plastic rods in the tent sleeves and then slide the tent into the extrusions? Or slide the rods into the sleeves after the tent sleeve is in the extrusion?
- is there a side that you recommend doing first or last?
- do I want the tent poles in place or can they be put in afterwards?
Any suggestions or points would be greatly appreciated!!!
Thanks,
Tim
For instance:
- should I put the plastic rods in the tent sleeves and then slide the tent into the extrusions? Or slide the rods into the sleeves after the tent sleeve is in the extrusion?
- is there a side that you recommend doing first or last?
- do I want the tent poles in place or can they be put in afterwards?
Any suggestions or points would be greatly appreciated!!!
Thanks,
Tim