Rear disc brake conversion kit?

[kellymoe]

Yeah, that's what I linked to, only from lrseries.

Interesting, the guy who did it here, http://forums.lr4x4.com/index.php?showtopic=11685 actually added a spacer. But maybe he was using different calipers. I haven't gone back and read it in detail again.

That write up is just what I need along with Keith's expertise. Do the pictures in that write up show for you? It's a no go for me but the write up is so good that I don't need it.

Thanks again, the tech archive section of that forum is a goldmine.

 

[LandyAndy]

Always call him. He can get just about anything, it's not all on the website by any stretch.

Yup on there..... click the XEng logo on the home page....

 

[Antichrist]

That write up is just what I need along with Keith's expertise. Do the pictures in that write up show for you? It's a no go for me but the write up is so good that I don't need it.

Thanks again, the tech archive section of that forum is a goldmine.

Yup, they are showing up for me.

Yeah, lot of goodies there.

 

[mongosd2]

Several of the write ups I have seen were using 87-89 Range Rover rear caliper brackets (close to free and readily available these days).

I have both at the shop...I'll check the rrc calipers to see the difference...

 

[Michael Slade]

Have you seen what Timm ended up doing on my truck? All stock parts except for the brackets we cut out of 1/2 inch plate and welded them to the axles.

We used vented RRC front rotors/calipers and had to swap out the stub axles to accommodate the wider hub.

So far no problems with the Hydroboost brake master cylinder.

 

[kellymoe]

Michael,

That looks nice, I am getting excited about diving into a project, it's been too long. I still have a engine sitting in the garage with all the parts ready to rebuild, I just need the time.