Nov ‘23 Kingpin 40” V-series Light Bar
Several months ago Kingpin approached us and asked if we would be interested in trying out one of their lights. Pretty excited we said yes! We installed their V-SERIES 40" LIGHT BAR and Smart Touch Dimmer Switch on the rear hatch of our GFC using VHB tape...
August ‘23, Drip Rail Install
We had been waiting to do this mod for a while. Adding the Drip Rails to our camper will vastly improve it on rainy days and solve an annoying issue of water dripping off the leading corners of our camper and into the rear doors of the truck when they are open...
I think it's on there about as well as it could be! My best estimate is that the box weighs roughly 3500lbs fully built out and will a full load when its lived in (ie: food, water, clothes, and personal items), I feel pretty confident that the truck could go onto its side and the box would stay...
I can gather more photos of how the box is attached but in this google album there are some that show it. I did not use the s280 kit. I had difficulty finding one and did not like that it would have meant the use of chains, rather the cable, as well the chains would have run across the side...
the short story is we had it parked in our condo parking lot, it was parked in the same spot while we have been traveling for the last 1.5 years, and it's supposed to move every 14 days. We overstayed our welcome just by a little....
Thankfully it was properly towed, tow bill still ended up...
I can go out to the truck in a few days to take proper measurements, Probably should have listed this in the ad. But if my memory serves me right it is 6'6" long and roughly 55" wide.
here is a link to a google album with a bunch of additional photos, ExPO sometimes will not allow me to upload photos due to their size.
Correct, Peanut can carry 42 gallons of fresh water, there is a grey water system, that drains from the sink into a 7-gallon container.
We have a...
The last change that we wanted to make over the previous build was the level of finish on our wood. The finish that we used last time just didn’t hold up well to the use that we put out setup through, I think most of it was to blame for only using two coats. This time we spent nearly as much...
We secured the fridge like we had before using the same L-Track hardware and NRS straps that we had used in the previous version of our build.
In our previous build, we covered all our clothes and food in a similar way with a simple wood lid, that worked great but had one small problem. The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.