Does anyone else have this “issue” and if so, what are you doing about it? I’ve had a CVT and and ARB and they both had the portico that covered the ladder. The Eezi Awn fly keeps disengaging from the spring rods when it is windy. So I tether it. But still not an ideal set up.
@Epix Have at it, and thank you for the kudos. There have been a few on this site and Mud over the years that I have drooled over. The Horizon seems much more practical, but as with most practical things, it doesn’t stir my soul in the same way.
Looking at your profile I didn’t see a...
Finished up the ARB compressor install. I dismantled the harness and removed the turquoise and yellow wires that control the locker solenoids, cleaned up the power and ground leads and routed around the engine bay to a newly installed 40 amp breaker. The red wire that is attached to the...
@Kingsize24 Thanks. I just need to get out more. My goal is fewer Marriott nights and more Eezi Awn stays, just need to quit my job… and sell the house… and get the young adults off the payroll. ;-).
Spent some time with friends in the Mark Twain Natl Forest. Turkey hunting was the weekends goal, and I was asked to cook up some nuggets. Perfect flame grill set in the IGT “3” table was great. Whole set up worked well.
Started working on this. ARB CMKA12 mounted to the Owl Expedition, well, mount. Took a minute to figure out what needed to be relocated on Moose and found it wasn’t much.
Before:
After:
The alarm horn ticks in behind with a little tweak and the resistor bolts to the provided extra...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.