Search results

maybe if you let us know what do you plan to install the refrig? in, the Nissan or a trailer/camper. It would help if you stop calling thermoelectric a RV cooler or refrig. A chest type refrig is like a home refrig you can control the temp. brian

Army Rims Power coat should seal the inside of the rims. see my PM. thanks=brian

Fridge all the way Don't buy a cooler, cheap and will not keep food/beer cold. Get a 12 Volt chest refrig however they cost.

M416 Temporary RTT/Boat setup I added 4 stake bed brackets (ebay) to the bed of my M416. I can now carry ladders, RTT, bike rack, boat/kayak, and still use room in the bed. I can change the height of the side beams as needed. Can be the start of a wooden lid/cover. Just FYI=brian

X2, I did use epoxy paint on the rims, before remounting tubeless tires. No problem. (NOTE:Original army rims have a number stamped on the lug nut flange.) the balance on these tires was dead on. thanks=brian

I also have cooper at3 on my tow unit, thanks on my trailer.

The original tires were dated 1965 and still held air but side walls were cracked and rode like hard solid rubber tires. So I brought low rolling resistance Cooper tubeless tires AT3 and mounted them on original army rims, mounted they do not stick out from the fenders and rode smooth on the...

Bump= for those who missed this easy Mod/update. thanks

Run silent, run without heavy noisy chains. Updated to 7/16"security covered wire, cut 60" bike lock cable in half and swagged new loop with a 7/16"ferrule to attach to the trailer. Just FYI=brian see pics

narrow rims I also went with Cooper AT3 in size 215/85-16 on my M416 trailer. Which rims are 4.5x16. fit very good, Ride great.

You can look up info on RV DOT rules on-line or try RVIA is a national association representing RV manufacturers and parts suppliers who together produce more than 95% of all RVs manufactured in the United States. Over 500lbs GVW needs brakes, rear light must be DOT approved, It looks great...

Go tubeless.

Type of Jacks ???? Are these the Jacks you mean? ...the choices for parking at the shore are four standard "screw-type" jacks with proper support. I guess the ones they use on mobile home would work. If you have a picture of the type of jack you need.

no more. check below thread on this subject, guess they are no more in business. FYI

Dave. No problems with original crank for clearance, Just thought I can make the crank better and easier to wind-up roof. And it does.=brian

Found a sail boat winch handle for $5.00 and ordered a new modified gear assy from "Canvas Replacements" drilled out old sail boat nose piece and installed with drive pin the new gears. The new gears have a longer gear teeth. They also sell the new nose gear on EBay--eBay item...

heco lift systems look up=heco crank lift system you will see pics of what you need. I brought mine from CANVAS REPLACEMENTS. FYI brian

18 LED problem I ordered an 18 red LED light from EBay for testing =seller (trailershoppe in PA) Came without wire harness, and I had to Dermal the red lens off. I cannot recommend,. Just FYI=brian

Roof hold-down clips I'm thinking some kind of heavy duty spring clips , Have you thought of fishing Super long lasting Urethane rod holders that are used on boats, I use them for flash holder see pics

Keith, Go to Hemet RV and look under siding patterns. brian