Search results

nothing like the power of a sail

bid to $130K, no sale

Not sure of the OP skill level, but $1k isn't much margin or margin for error in my opinion.

Great sheet metal, should probably be saved, but will be a labor of love, not profit unfortunately. Not a Gen 1 Bronco.

congratulations and good luck!

If your LS is a 3.0l it will be a 9" rear. 3.5l is 9.5" rear.

Engineering re-certification by a DIY modified vehicle that you personally own isn't really needed in the USA.

chop chop

4G63 (Gen 1 MM) narrow block & 4G64 (Gen 2 MM) wide block

Fits fine, installed last night. It took about 1 week to arrive.

sounds correct

I bought one as well. Arrived a couple days ago, have not had a chance to mess around with it yet.

Powerstops in my '05. Work just fine.

propane kicks out a lot of water unless its externally vented forced air. Not sure about the little fireplaces. The diesel heaters do require 12V (or 24V) to run. Current prices are really cheap, ~$120 delivered on Amazon

I bought a used Edgestar (Whynter) FP430 around 8 years ago. No idea how old it was when I bought it. Has been plugged in either my vehicle or basement nearly 100% of my ownership time and has worked flawlessly.

Diesel heater: https://www.amazon.com/gp/product/B08G4MTL3T

Mitsubishi owns 15% of Jatco

Tough to prove without a tag stating manufacture, OEMs pretty much ended that in the 2000s. I know we don't label anything anymore for the OEMs. Could be that Jatco sources the shift solenoids from Aisin - nobody make everything these days.

That is going to be a rust belt vehicle as well.